DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-213ATM-EI (Expansion Interface Circuit Pack)
9
1003 ABORT The system could not allocate a tone receiver for the test. The
system may be oversized for the number of tone detectors present,
or some tone detectors may be out of service.
1. Resolve any TTR-LEV errors.
Even if there are no TTR-LEV errors, there may not be a tone
detector available on the network that contains the circuit pack
being tested. Verify that there is at least one tone detector on
the network. If not, this test always aborts for this ATM-EI circuit
pack and does not harm the system.
2. Resolve any TONE-PT errors.
3. If neither condition exists, retry the command at 1-minute
intervals a maximum of 3 times.
1962 ABORT All DSPs are busy (an unlikely event).
1. Retry the command at 1-minute interva ls a maximum of 3 times.
2000 ABORT Response to the test was not received within the allowable time
period for some of the DSPs.
1. If the board is in standby, reset the board and run the test ag ain
once the board is inserted.
2. Look into the Error Log for Error Type 1218 (bad DSP). If Error
Type 1218 is not logged against this board, run the DSP test
again and see if the error persists.
2100 ABORT Could not allocate the necessary system resources to run this test.
2302 ABORT Inconsistent uplink message from the ATM-EI board (an unlikely
event).
1. Retry the command at 1-minute interva ls a maximum of 3 times.
2500 ABORT Internal system error
2752 ABORT The circuit pack in this location is not a TN2305/6.
Table 9-91. ATM Board DSP Test (#1293) — Continued
Error Code Test
Result Description/ Recommendation
Continued on next page