Lucent Technologies Release 7 9-833EXP-INTF (Expansion Interface Circuit Pack)

DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4 June 1999
Maintenance Object Repair Procedures
9-833EXP-INTF (Expansion Interface Circuit Pack)
9
1421 ABORT This abort code appears only when the Expansion Interface circuit pack
addressed in the test command is one that terminates a fiber link between two
EPNs in a direct connect system. It indicates that the test failed, but that this
test was run on the EPN EI board that is: a) in the same EPN as the board under
test b) on the active PNC (if duplicated) c) terminates the fiber from the PPN
The EI tested is probably not at fault.
1. Enter display alarms and fol low the EXP-I NTF repair proced ures for any
alarms against the EPN EI that is:
a. In the same EPN as the board just tested
b. On the active PNC
c. Terminates the fiber link from the PPN
2. If there are no alarms logged against that EI, run Test #589 on it and follow
procedures for this t est.
3. Try this command again.
1422 ABORT This abort code is valid and will only appear when the EI circuit pack under test
is one which is located in an EPN in a system that is configured with a Center
Stage Switch. It means that the test failed, but that this test was then run on the
PPN EI on the same PNC as the EI under test and that test failed. This means
that the EI originally tested is probably not at fault.
1. Resolve any alarms that are logged against the PPN EI that is on the same
PNC as the EI under test.
2. If there are no alarms logged against the PPN EI, run Test #589 against the
PPN EI and follow procedures for this test.
3. Try this command again.
2000 ABORT Response to the test request was not received within the allowable time period.
1. Retry the command at 1-minute intervals for a maximum of 3 retries.
2060 ABORT The link on the Packet Bus b eing used to perform the test has fail ed.
1. Retry the command at 1-minute intervals a maximum of 3 times.
2. If the test continues to abort, enter display errors and resolve any PKT-INT
errors.
2100 ABORT Could not allocate the necessary system resources to run this test.
2500 ABORT Internal system error
1. Retry the command at 1-minute intervals a maximum of 3 times.
Table 9-315. TEST #589 Expansion Interface Packet
Interface Test — Continued
Error
Code Test Result Description/ Recommendation
Continued on next page