DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-561DISK (MSS Disk Circuit Pack)
9
2000 ABORT Response to the test request was not received within the allowable time period.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2500 ABORT Could not run the test on the Standby SPE—Internal software error.
1. Retry the command at 1-minute intervals for a maximum of 5 retries.
5102 ABORT Could not allocate the Mass Storage System to run this test
1. Retry the command at 1-minute intervals a maximum of 5 times.
2. If the test continues to abort, verify that the daily translation-save operation
is not in progress (issue the display system-parameters maintenance
command to display the time for scheduled maintenance and the "y/n"
option for saving translation daily).
NO
BOARD The disk has been placed in the "uninstalled" state.
1. Verify that the disk drive is fully inserted and powered up.
2. Attempt a demand reset of the disk.
5513 FAIL The system is equipped with 3 memory circuit packs but the c apacity of the
disk is not large enough for the coredump file.
1. Use list configuration control and verify that the control carrier is
equipped with 3 memory boards. Also check the vintage of the TN1657
Disk Drive circuit p ack.
2. Replace the Disk Drive circuit pack with Vintage 4 or greater, issue the
reset disk command, and perform the restore disk command. The restore
operation may take up to 1 hour to complete.
5514 FAIL The system is equipped with 3 memory circuit packs but the disk has not been
configured for a large coredump file. The tap e and disk should be c onfigured
for the larger memory size as part of the procedures for installing 3 memory
circuit packs.
1. Use configure tape 3-mem to ensure that the file system on the tape has
been configured for the large core dump file. This command will not
execute if the tape has already been configured.
2. Use restore disk. This step may take up to 1 hour for a complete restore.
3. Execute the test disk R command to clear the alarm.
Table 9-230. TEST #815 Disk Status Test — Continued
Error
Code Test
Result Description/ Recommendation
Continued on next page