DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-1063MMI-BD
9
TSI Crosstalk Test (#6)
This test is non-destructive.
The Time Slot Interchanger (TSI) chip controls connect ivity to the TDM bus. The
TSI Cross Talk Test verifies that this TSI talks on the selected TDM bus time slot
and never crosses over to time slots reserved for other connections. If the TSI is
not working correctly, one-way and noisy connections may occ ur. If the test
passes, then the TSI is able to communicate ov er the TDM bus. This test is part
of the circuit pac k’s demand and sc heduled long test sequence, and takes
approximately 20 to 30 second s to complete.
Table 9-422. System Technician-Demanded Tests: MMI-BD
Order of Investigation Short Test
Sequence Long Test
Sequence Reset Board
Sequence D/ND1
1. D = Destructive, ND = Non-destruc tive
TSI Crosstalk (#6) X ND
TSI Looparound Test (#1108) X ND
MMI SYNC Status Test (#1123) X ND
MMI SYNC Status Test (#1122) X ND
Control Channel Looparound Test (#52)2
2. Refer to the repair proced ure described in XXX-BD (Common Port Circuit Pack) for a description
of this test.
XX ND
SAKI Sanity Test (#53)2XD
Continued on next page
Table 9-423. TEST #6 TSI Crosstalk Test
Error
Code Test
Result Description/Recommendation
ABORT Internal system error. This is an abnormal abort.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1002 ABORT The system could not allocate time slots for the test, the traffic load on the
system is very high, or the time slots are out-of-service due to TDM-BUS errors.
1. If the system has no TDM-BUS errors and is not handling heavy traffic,
repeat the test at 1-minute intervals a maximum of 5 times.
Continued on next page