Lucent Technologies Release 7 Switch Node Clock Reset Test (#780)

DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4 June 1999
Maintenance Object Repair Procedures
9-1415SNC-BD (Switch Node Clock Circuit Pack)
9
Switch Node Clock Reset Test (#780)
This test is destructive.
This test resets the SNC circuit pack via the reset board UUCSS command when
an SNC circuit pack loc ation is entered. If the system has PNC dup lication, the
active SNC on the active PNC cannot be reset.
If the SNC is active and the reset board command is executed, an SNI in the
same carrier as the SNC will be told by s oftware to reset the SNC via the TPN link.
If no inserted SNIs in the same carrier as the SNC can suc cessfully reset the
SNC, software will send a reset message direc tly to the SNC. Software first tries
to reset the SNC via an SNI in case the SNC is insane because the latter method
(sending the reset message d irectly to the SNC) will not work if the SNC is
insane.
If an active SNC is reset and a standb y SNC exists in the same switch node
carrier, the standby SNC will b ecome active. The reset board command should
not be used to make a stand by SNC active. Instead, the set switch-node-clock
UUCSS command should b e used.
If the SNC is standby and the reset board c ommand is executed, the a ctive SNC
is told by software to reset the stand by SNC via the TPN link.
An SNC should be reset instead of reseating the circuit pac k. The reset board
command should almost nev er be used on an SNC. It may be nec essary to use
the reset board command if the SNC circ uit pack gets into a m ode where it
cannot communicate with so ftware.
Table 9-555. TEST #780 Switch Node Clock Reset Test
Error
Code Test Result Description/ Recommendation
2100 ABORT Could not allocate the necessary syst em resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 3 times.
2300 ABORT The downlink message necessary to run this test could not be sent.
1. Retry the command at 1-minute intervals a maximum of 3 times.
2301 ABORT The software timer could not be set before sending the downlink message
necessary to run this test.
1. Retry the command at 1-minute intervals a maximum of 3 times.
2302 ABORT Software received unexpected message data from the SNC circuit p ack.
1. Retry the command at 1-minute intervals a maximum of 3 times.
Continued on next page