DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures

9-1413SNC-BD (Switch Node Clock Circuit Pack)

9
TPN Test (#779)
This test is non-destructive.

This test queries the SNC circuit pack for stat us of the ROM and internal RAM

background tests for the TPN microcontroller.

0NO
BOARD No board was detected by the test.
1. Check that SNC board is properly translated and inserted.
2. Run the test again. If it fails, reset the board. An SNC should be reset
instead of reseating the circuit pack. The reset board command should
almost never be used on an SNC. It may be necessary to use the reset
board command if the SNC circuit pack gets into a mode where it cannot
communicate with software. If an SNC with active errors and alarms is
reset, the errors and alarms may take a while to come back, therefore the
reset board command can mask real problems.
3. Run the test again. If it fails, the ID chip on board may be bad. Replace the
board and retest.
Table 9-554. TEST #779 TPN Test
Error
Code Test
Result Description/ Recommendation
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 3 times.
2300 ABORT The downlink message necessary to run this test could not be sent.
1. Retry the command at 1-minute intervals a maximum of 3 times.
2301 ABORT The software timer could not be set before sending the downlink message
necessary to run this test.
1. Retry the command at 1-minute intervals a maximum of 3 times.
2302 ABORT Software received unexpected message data from the SNC circuit p ack.
1. Retry the command at 1-minute intervals a maximum of 3 times.
Continued on next page
Table 9-553. TEST #778 SNC On-Board Test — Continued
Error
Code Test
Result Description/ Recommendation
Continued on next page