DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-1196PGATE-BD (Packet Gateway Circuit Pack)
9
Notes:
a. This error indicates that the circuit p ack has stopped functioning or was
physically removed from the system. Check too see whether the circuit
pack is present in the slot ind icated by the error. If the circ uit pack is there,
then reset it with reset board UUCSS. If the error persists, than replac e
the circuit pac k.
b. Packet Gateway circuit p ack has been busied out by command.
c. Packet Gateway circuit p ack has not been administered for the slot in
which it is inserted.
d. This error indicates transient c ommunication problems between the switch
and this circuit pac k. This error is not service affecting and can b e ignored
unless repeated failure of the Control Channel Loop -Around Test indicates
a hardware failure of the circuit pa ck.
e. A hardware failure on the circuit p ack has been detected and reported b y
the circuit pac k. These errors are detected by initialization or b ackground
tests which run on the circuit p ack. The detection of one of these errors
causes the circuit pack to "lock up" and appear insane to the system See
error type 1.
The reported aux data values c orrespond to the following dete cted errors:
f. This error is reported by the circ uit pack when it detec ts a program logic
error. This error can be ignored, b ut may lead to errors of other types
being reported against this circuit pack.
g. This error is reported by the c ircuit pack when it cannot up date NPE
memory and read it bac k. This error type can be ignored, b ut may lead to
errors of other types being rep orted against this circ uit pack.
h. A critical hardware or firmware failure has b een detected on the c ircuit
pack. The switch resets the circ uit pack upon the repor t of one of these
errors. If three of these errors are received in 15 minutes, a MINOR alarm
is raised on the circuit p ack. Try clearing the alarm by executing the reset
board UUCSS command. The circuit p ack should be rep laced if this
alarm cannot be resolved.
The reported error types corresp ond to the following detected errors:
4352: External RAM error
4353: Internal RAM error
4355: ROM Checksum error
4357: Instruction set error