Lucent Technologies Release 7 9-832EXP-INTF (Expansion Interface Circuit Pack)

DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4 June 1999
Maintenance Object Repair Procedures
9-832EXP-INTF (Expansion Interface Circuit Pack)
9
1139 ABORT The Packet Bus in the Expansion Port Network where this Expansion Interface
circuit pack is located has a major alarm against it. This test needs to use the
alarmed port network’s Packet Bus.
1. Enter display alarms and resolve any PKT-BUS alarms.
2. Retry the command.
1141 ABORT The Packet Interface circuit pack is out of service.
1. Refer to ‘‘PKT-INT (Packet Interface Circuit Pack)’’ for the recommended
repair proced ure.
1144 ABORT The Packet Bus in the PPN has a major alarm against it. This test needs to use
the alarmed PPN Packet Bus.
1. Enter display alarms and resolve any PKT-BUS alarms.
2. Retry the command.
1394 ABORT The Expansion Interface circuit pack is out of service and the test cannot be
run. This condition is due to a change in the Expansion Interface circuit pack’s
ability to communicate with the Expansion Interface or Switch Node Interface
circuit pack on the other end of the fiber.
1. Run Test # 237 and c heck t he Error Lo g for EXP-IN TF Error Type 1 281. If
Error Type 1281 is present or if Test #237 does not pass, refer to the repair
procedures for Test #237.
2. If Test #237 passes, rest the Expansion Interface pack. Note that this will
not be destructive to the port network that the Expansion Interface circuit
pack is located in because it will not be servi ng as the expansion
archangel if it is not in service.
3. Repeat this test.
1395 ABORT This test cannot be run on an Expansion Interface circuit pack if it is part of the
B-side Port Network Connectivity and Duplicated Port Network Connectivity is
not enabled.
1. If this test needs to run on this Expansion Interface circuit pack, enable
Port Network Connectivity with the change system-parameters
duplication command.
2. Prevent the system from doing a PNC interchange by executing the set
PNC lock command.
3. Repeat this test.
Table 9-315. TEST #589 Expansion Interface Packet
Interface Test — Continued
Error
Code Test Result Description/ Recommendation
Continued on next page