DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-875FIBER-LK (Fiber Link)
9
234 FAIL No neighbor link is administered, but the SNI (endpoint 2) has an SNI neighbor
(list fiber-link can be used to display fiber link endpoints).
1. Administer the SNI on a fiber link to the SNI neighbor it is connected to via
the add fiber-link next command. Or remove both fiber endpoints (i.e., this
SNI a nd its SNI neigh bor) and r emove the fiber endpoint s from circuit pack
administration via change circuit-pack.
235 FAIL The SNI circuit pack (endpoint 2) cannot communicate with its neighbor (list
fiber-link can be used to d isplay fiber link endp oints). The SNI has an
administered neighbor, but cannot communicate with its neighb or.
1. Check if the administe red neighbor is inserted . If not, insert the neighbor
circuit pack.
2. Perform the ‘‘Fiber Fault Isolation Procedure’’.
236 FAIL The endpoint 2 SNI’s administered neighbor does not match the physical
neighbor connected (list fiber-link can b e used to display fiber link endpoints).
The type of neighbor administered is an SNI and the type of neighbor
physically connected is an EI. Enter list fiber-link and verify that the fiber optic
cable and metall ic cable connec t ions are installed as administered .
237 FAIL The endpoint 2 SNI’s administered neighbor does not match the physical
neighbor connected (list fiber-link can b e used to display fiber link endpoints).
The type of neighbor administered is an EI and the type of neighbor physically
connected is an SNI. Enter list fiber-link and verify that the fiber optic cable
and metallic cable connections are installed as administered.
238 FAIL The physical neighbor location of endpoint 2 SNI does not match administered
neighbor locati on (list fiber-link can be used to display fiber link endpoints).
The carrier and slot of the administered neighbor do not match the carrier and
slot of the physical neighbor. Enter list fiber-link and verify that the fiber optic
cable and metall ic cable connec t ions are installed as administered . If the
problem does not seem to be caused by a physic al connection problem or an
administration problem, replace the neighbor ci rc uit pack. It is possible for the
neighbor circuit pack to have a hardware p roblem that causes it to report a
wrong angel address (physical carrier/slot add ress) to software.
Table 9-333. TEST #759 Configuration Audit — Continued
Error
Code Test
Result Description/ Recommendation
Continued on next page