DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures

9-736DUPINT (Duplication Interface Circuit Pack)

9
Mailbox Loop-around Test (#866)
This test is destructive.

This test checks the functionality of the ma ilbox mechanism provid ed by the

Duplication Interface circuit pack

Local Loop-around Test (#867)
This test is destructive.
Table 9-283. TEST #866 Mailbox Loop-around Test
Error
Code Test
Result Description/ Recommendation
1405 ABORT This test did not run because the Duplication Channel was busy.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1418 ABORT The HFAIL bit and/or the STDONE bit is in the wrong state. The active
Duplication Interface circuit pac k needs to be reset.
1. Run the test duplication-interface long command and follow instructions
for the Active DUPINT Reset Test (#870).
2. If test #870 passes and this test still aborts, escalate the problem.
2500 ABORT Internal system error
1. Retry the command at 1-minute intervals a maximum of 5 times.
FAIL The test message written into the active Duplication Interface circuit pack
mailbox did not cause an interrupt to notify the software to retrieve it from the
receive mailbox; or if retrieved, the looped back message did not match the
message written into the mailbox.
1. Replace Duplication Interface comp onents starting with the active
Duplication Interface circuit pack. Use SPE Duplication Channel
Component Replacement procedures at the end of the DUP-CHL section.
55 FAIL The attempt to turn off memory shadowing in this Duplication Interface circuit
pack could not be verified in the Duplic ation Interface circuit pack hardware
status register.
1. Replace Duplication Interface comp onents starting with the active
Duplication Interface circuit pack. Use SPE Duplication Channel
Component Replacement procedures at the end of the DUP-CHL section.
PASS The test message written into the active Duplication Interface circuit pack
mailbox successfully caused an interrupt to notify the software to retrieve it
from the receive mailbox and the retrieved looped back messag e matched the
message written into the mailbox.
Continued on next page