DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures

9-771ETH-PT (Control LAN Ethernet)

9
Session Status Test (#1286)

This non-destructive test determ ines the status of all Ethernet port sessions. This

test queries the system software on port sess ion status.

If the system software indicates

that: Then the switch:

All port sessions are up (ALL UP) Raises no alarm, or retires alarm
Some port sessions are up (SOME UP) Raises WARNING alarm
All port sessions are down (ALL DOWN) Raises MINOR alarm
Table 9-300. TEST #1286 Session Status Test
Error
Code Test
Result Description/ Recommendation
1124 ABORT Ethernet link is not enabled.
1. Verify that the Ethernet link is enabled (status port UUCSSpp, status
link
n
, or display data-module).
2. If the link is not enabled, enable the link (change data-module).
3. Repeat the test.
1125 ABORT Ethernet link not in servic e.
1. Verify whether Ethernet link is in service (status port UUCSSpp or
status link n).
2. If the Ethernet link is not in service, release the link (release link n or
release port UUCSSpp).
3. Repeat the test.
2000 ABORT Did not receive circuit pack test response within the allowable time period .
1. If the problem persists, reset the circuit pack (busyout port UUCSSpp
and reset board UUCSS).
2. If the problem persists, replace the circuit p ack.
2100 ABORT Could not locate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals, up to 5 times.
2500 ABORT Internal system error.
1. Retry the command at 1-minute intervals, up to 3 times.
1 FAIL System software indicates at least one Ethernet link session is down (SOME
UP).
1. Isolate downed sessions (status port UUCSSpp or status link n).
2. Follow actions based on session information.
Continued on next page