DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures

9-899H-ADAPTR (MSS Host Adapter)

9
Host Adapter Diagnostic Test (#823)

The Host Adapter Diagnostic test runs a set of non-destructive d iagnostic tests

for the Host Adapter. This includ es tests requiring system bus mastership.

Specific tests include:

1350 ABORT Could not run the test on the Standby SPE—Shadowing not enabled.
1. When the standby is restored to service (use status spe to determine
state of standby) retry the command.
2000 ABORT Response to the test re quest was not received within the allowable time period.
1. Retry the command at 1-minute intervals a maximum of 5 retries.
2500 ABORT Could not run the test on the Standby SPE—Internal software error.
1. Retry the command at 1-minute intervals a maximum of 5 retries.
5102 ABORT Could not allocate the Mass Storage System to run this test
1. Retry the command at 1-minute intervals for a maximum of 5 retries.
2. If the test continues to abort, verify that the daily translation-save operation
is not in progress (issue the display system-parameters maintenance
command to display the time for scheduled maintenance and the "y/n"
option for saving translation daily).
NO
BOARD The host adapter has been placed in the "uninstalled" state.
1. Verify that the host adapter is fully inserted and powered up.
2. Attempt a demand reset of the host adapter.
1FAIL The Read and Clear Firmware Error Counters test detected a non-zero
firmware error counter.
1. Retry the command at 1-minute intervals a maximum of 5 retries.
2. If the command continues to fail, replace the MSSNET circuit pack (see the
circuit pack replacement section above) and issue the test mssnet long
command.
PASS The Read and Clear Firmware Error Counters test completed successfully
without detecting a non-zero firmware error counter. Look at the results of other
tests to see if it is operating correctly.
1. See the MSS Error Actions table at th end of the section on TAPE.
Table 9-343. TEST #822 Host Adapter Read and Clear Firmware
Error Counters Test — Continued
Error
Code Test
Result Description/ Recommendation
Continued on next page