DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures

9-1465SNI-BD (SNI Circuit Pack)

9
Switch Node Interface Reset Test (#761)
This test is destructive.

This test resets the SNI circuit pack via the reset board UUCSS command when

an SNI circuit pack loc ation is entered. The SNI is reset via the active SNC circuit

pack in the carrier. If the SNI is c onnected to the PPN EI, the SNI is reset via its

PPN EI neighbor. If an SNI with an EPN EI or another SNI as its neighbor cannot

be reset via the active SNC, i.e., if no software commu nication exists between the

140 FAIL The SNI is physically connected to a DS1C but is not administered to be
connected to a DS1C.
Either add the DS1 converter complex to the fiber that this SNI is associated
with by:
1. Determine which fi ber that this SNI is an endpoint of by checking list
fiber-link.
2. Remove this fiber with the remove fiber-link command.
3.Add the fiber back via add fiber-link, and at this time also administer the
DS1 converter complex.
Or:
1. Remove the DS1C connection and connect the SNI directly to its
administered fiber endpoint.
2. Verify that the fiber optic cable and metall ic cable connec tions are
installed as administered by entering list fiber-link.
PASS The administered data and the circuit packs the SNI can communicate with
match.
0NO
BOARD No board was detected by the test.
1. Check that board is properly translated and inserted.
2. Run the test again. If it fails, reset the board. An SNI should be reset
instead of reseating the circuit pack. The reset board command should
almost never be used on an SNI. It may be necessary to use the reset
board command if the SNI circuit pack gets into a mode where it cannot
communicate with software. If an SNI with active errors and alarms is reset,
the errors and alarms may take a while to come back, therefore the reset
board command can mask real problems.
3. Run the test again. If it fails, the ID chip on board may be bad. Replac e the
board and retest.
Table 9-562. TEST #759 Configuration Audit — Continued
Error
Code Test
Result Description/ Recommendation
Continued on next page