DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures

9-713DUP-CHL (Duplication Interface)

9
State-of-Health (#873)
This test is destructive.

This test verifies the correct operation of the State-of-Health inter rupt

Table 9-276. TEST #873 State-Of-Health Test
Error
Code Test
Result Description/ Recommendation
1321 ABORT The faceplate switches on the Dup lication Interface circuit pac ks are not set to
auto.
1. If the switches are locked because you are using a replacement
procedure, continue with this procedure to the step that directs you to
unlock the active SPE by moving both switches to auto. The next step
using the test duplication-interface long clear should not abort with this
error code.
2. If the switches are locked and a replacement p rocedure is not being used,
start with step 6 of the SPE Duplication Channel Component Replacement
procedure for the standby Duplication Interface Circuit p ack at the end of
this DUP-CHL section to avoid an undesired interchange when unlocking
the active SPE.
3. If this same abort is received with both switches in auto, replace
Duplication Interface components starting with the standby Dup lication
Interface circuit pack. Use SPE Duplication Channel Component
Replacement procedures at the end of this section. In addition to looking
for failures, also check for the absence of this 1321 abort code when
testing after the procedure directs setting the switches to auto after a
component replacement.
1405 ABORT This test did not run because the Duplication Channel was busy.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1411 ABORT This test did not run because the standby Duplic ation Interface circuit pack
cannot be detected as being plugged in by the software.
1. If this abort continues to occur, the standb y SPE may not have initialized
properly. Use the lock-and -power-down p rocedure desc ribed in Chapte r 5
to power down and power up the standby SPE, but don’t replace any
circuit packs.
Continued on next page